Piaggio Vespa Ignition Switch PX (-1984 2 Wire) Non Electric Start T5 (Some PK Models) SEALS & BEARINGS (Supplied without ALL Bearings and

(Supplied without ALL Bearings and races must be bought separately)

One required for each side panel Comparison Part No

Sometimes a standard clutch isn't up to the longevity of a 'banded clutch'

Alternatively use it to install your genuine Vespa top case

it therefore requires a battery or another equivalent power source with 12V DC

Piaggio Vespa Ignition Switch PX (-1984 2 Wire) Non Electric Start T5 (Some PK Models) SEALS & BEARINGS (Supplied without ALL Bearings andPiaggio Vespa Ignition Switch PX ( 1984 2 Wire) Non Electric Start T5 (Some PK Models) The Vespa PX, T5 Ignition Switch is fitted on the back of the Frame Lock Tube.. This part is then held on by a grub screw (sold separately). The Ignition is then fitted to the Harness. Advice: check wiring diagram for correct fitting. Remember! the new style Electric start model has 3 wires, the non electric start models has only 2 wires. Comparison Part No. 178593